Traxxas 70054-1 User Manual download pdf (Page 15)

1/16 SLASH 4WD

•

THE TRAXXAS TQ 2.4GHz RADIO SYSTEM

Higher Speeds Require Greater Distance

The faster you drive your model, the more quickly it will near the

limit of radio range. At top speeds, models can cover anywhere

between 50 to 100 feet every second! It’s a thrill, but use caution to

keep your model in range. If you want to see your model achieve its

maximum speed, it is best to position yourself in the middle of the

truck’s running area, not the far end, so you drive the truck towards

and past your position. In addition to maximizing the radio’s range,

this technique will keep your model closer to you, making it easier

to see and control.

No matter how fast or far you drive your model, always leave

adequate space between you, the model, and others. Never drive

directly toward yourself or others.

TQ 2.4GHz Binding Instructions

For proper operation, the transmitter and receiver must be electronically

‘bound.’ This has been done for you at the factory. Should you ever

need to re-bind the system or bind to an additional transmitter or

receiver, follow these instructions. Note: the receiver must be connected

to a 4.8-6.0v (nominal) power source for binding and the transmitter and

receiver must be within 5 feet of each other.

1. Press and hold the SET button on the transmitter.

2. Turn on the transmitter and release the SET button. The status LED will

flash red slowly, indicating that the transmitter is in bind mode.

3. Press and hold the LINK button on the receiver.

4. Turn on the speed control by pressing the EZ-Set button, and release

the LINK button.

5. When the LEDs on both the transmitter and the receiver turn solid

green, the system is bound and ready for use. Confirm that the

steering and throttle operate properly before driving your model.

TRANSMITTER LED CODES

LED Color / Pattern Name Notes

Solid green Normal Driving

Mode

See page 13 for information

on how to use the transmitter

controls.

Slow red

(0.5 sec on / 0.5 sec off)

Binding

See this page for more information

on binding.

Flashing medium red

(0.25 sec on / 0.25 sec off)

Low Battery

Alarm

Put new batteries in the

transmitter. See page 11 for

more information.

Flashing fast red

(0.125 sec on / 0.125 sec off)

Link Failure /

Error

Transmitter and receiver are no

longer bound. Turn the system

off and then back on to resume

normal operation. Find source of

the link failure (i.e., out of range,

low batteries, damaged antenna).

RECEIVER LED CODES

LED Color / Pattern Name Notes

Solid green Normal Driving

Mode

See page 13 for information

on how to use your transmitter

controls.

Slow red

(0.5 sec on / 0.5 sec off)

Binding

See this page for more information

on binding.

Flashing fast red

(0.125 sec on / 0.125 sec off)

Failsafe / Low-

Voltage Detect

Consistent low voltage in the

receiver triggers failsafe so that

there is enough power to center

the throttle servo before it

completely loses power.

Failsafe

Your Traxxas radio system

is equipped with a built-in

failsafe function that returns

the throttle to its last saved

neutral position in the event

of a signal loss. The LED

on the transmitter and the

receiver will rapidly ﬂash red

when the failsafe mode is

activated. If failsafe activates

while you are operating

your model, determine the

reason for signal loss and

resolve the problem before

operating your model again.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Comments to this Manuals

No comments

Traxxas 70054-1 User Manual Page 15

Comments to this Manuals

Related products and manuals for Toys Traxxas 70054-1